1. How Pymeter control temperature?
Temperature controller is actual Heating/Cooling controller, thus MUST SET ON-Temp to turn ON Heating/Cooling, and MUST SET OFF-Temp to turn OFF Heating/Cooling.
Heating starts at LOW Temp [ON-Temp(1oN, 2oN)], stops at HIGH Temp [OFF-Temp(1oF, 2oF)], thus for heating MUST SET 1oN(2oN) LESS than 1oF(2oF);
In heating mode, 1oN(2oN) is the minimum temp you allow, 1oF(2oF) is the maximum temp you allow.
Cooling starts at HIGH Temp [ON-Temp(1oN, 2oN)], stops at LOW Temp [OFF-Temp(1oF, 2oF)], thus for cooling MUST SET 1oN(2oN) GREATER than 1oF(2oF).
In cooling mode, 1oN(2oN) is the maximum temp you allow, 1oF(2oF) is the minimum temp you allow.
2. Reading temp is inaccurate?
Every Pymeter controller is calibrated before come out of factory, it is reading temp accurately!
Please don’t compare it to common inaccurate thermostat、thermometer or temp gun. If you doubt Pymeter controller accuracy, please calibrate with ice-water mixture (it is 32F when ice is melting), and you will see which device is accurate then.
【Temperature Control】Temperature can be preset to automatically turn on the heating and cooling equipment to maintain the optimal temperature
【Dual Relay System】Simultaneous connection of heating and cooling equipment is possible
【Dual Display Window】Simultaneous display of measured and set temperatures.Supports °C/°F display
【Alarm Device】Beeping alarm in case of high temperature or sensor failure to ensure target safety
【Plug and Play】Easy setup for a wide range of settings and devices
【Higher Power】Maximum output load: 1200W (10A). With temperature calibration and power-on delay function to avoid compressor from frequent switching on and off
【Versatile】It is used as temperature switches / thermostatically controlled outlet for heat mat / heat lamp / heating pad of reptile terrarium / tank, aquarium heater / chiller, greenhouse and grow tent heater, garage / attic exhaust fan, breeding, seedling and fermentation
